Supported Scales

 

This section lists the electronic scales supported by StarShip and their default (factory) settings.

 

Scale Type

Baud Rate

Parity

Data Bits

Stop Bits

HTRM Command

CubiScan 100, 110, 125, 150

9600

None

8

1

 

Detecto AS-400D/420D

1200  

None 

8  

1

  

Detecto AS-410D

9600

Odd

7

1

  

Fairbanks  

9600  

Odd 

7  

2

  

Mettler Toledo BCA-222

9600

Even

7

1

 

Mettler Toledo PS60 (see below), 8213  

9600  

Even 

7

1

Shift W

Mettler Toledo PS6L

9600

Even

7

2

  

Micro General 1270

9600  

Even 

7  

1

 

MOS 105405  

2400  

None  

8  

1

Ctrl B, Shift W, Enter

NCI 3835
(Choose Weightronix scale type)

4800  

Even 

7  

1

Shift W, Enter

NCI RS-7829
(Choose Weightronix scale type)

9600

Even

7

1

 

Pennsylvania 7X00

300

Odd

7

1

SRP, Enter

Pennsylvania 7400

4800

Even

7

1

S, R, or P

Transcell SP Series & SRP 300*

2400

None

8

1

Shift P

Weightronix  

1200  

Odd 

8

1

  

Weightronix WI-127 (Choose Toledo 8213)

9600

Even

7

1

  

 

*In the Device Manager, the flow control will need to be updated to "None".

 

 

 

Setting up the Toledo PS60 to emulate the 8213

 

The Toldeo PS60 Series of scales has multiple different 'modes' it can run in. To make sure it works with StarShip, we'll reset it to the factory defaults.

 

Note: The two buttons on the PS60 display are the [Select] button (the button with the two arrows going in a circle and the {ZERO} button (has a zero on it)

 

  1. Apply power to the PS60.

  2. Hold the {SELECT} button down, until [SetuP] appears in the display window.

  3. Press the {SELECT} button about 7 times to advance through the various setup categories until the display shows [END].

  4. Press the {ZERO} button to advance through the various protocols until the word [DEFAULT] appears on the display.

  5. Press the {SELECT} button and the unit will reboot and the protocol selection is complete.

    With the DEFAULT protocol selected, this indicator is now set for: